Lesson plan

Robot Wheel Math: Circumference Tells the Robot How Far to Go

Math40 minutesGrades: 7th
Robot Wheel Math: Circumference Tells the Robot How Far to Go

Overview

Use C = πd to program how far a robot wheel drives.

Description

Your teen uses cans and lids as robot wheels, measures their diameters, calculates circumference with C = πd, and writes a 'motor program' giving the number of wheel rotations needed to drive a set distance. Then they roll the wheels along a tape track to test their predictions.

Objective

Your teen will use the circumference formula to find how far a wheel travels in one rotation, calculate rotations needed for a target distance, test by rolling, and explain sources of error.

Standards

7.G.4Math · Grade 7 · Geometry
Know the formulas for the area and circumference of a circle and use them to solve problems; give an informal derivation of the relationship between the circumference and area of a circle.

Materials

ItemQuantity
Cylinders to act as wheels: soup can, jar lid, roll of tape, oatmeal canister3-4
Ruler or tape measure in centimeters1
Masking tape and a marker1 roll
Calculator1
Paper and pencil1 each
Smooth floor or table about 2 meters long1

Vocabulary

Circumference
The distance around a circle; C = πd.
Diameter
The distance across a circle through its center.
Rotation
One full turn of a wheel.
Encoder
A sensor on a robot's motor that counts how much the wheel has turned.

Preparation

Introduction

Roll a can one full turn along the floor and mark where it stops. Ask: 'A robot only knows how many times its wheels turned. How can it figure out how far it went?'
Would a bigger wheel go farther in one turn? How much farther?
Why might a robot measure distance by counting wheel turns?

Steps

1Step 1
Measure the wheels
(7 min) Your teen measures each wheel's diameter in centimeters to the nearest tenth and records it in the chart. They also wrap a strip of paper around one can to measure its circumference directly.
2Step 2
Calculate circumference
(7 min) Your teen uses C = πd with π ≈ 3.14 for each wheel and compares the calculation to the paper-strip measurement. Discuss why they are close but not exactly the same.
3Step 3
Write the motor program
(8 min) For each wheel, your teen calculates the rotations needed to travel 100 cm and 150 cm (rotations = distance ÷ circumference) and writes them as commands like FORWARD 4.2 ROTATIONS. They also work backward: if a wheel turned 6 times, how far did it go?
4Step 4
Test the program
(12 min) Your teen rolls each wheel along the tape track for the calculated number of rotations, counting the flag, and marks where it stops. They record the actual distance and the error in centimeters.
5Step 5
Explain the error
(5 min) Your teen identifies reasons the robot missed, such as slipping, measurement rounding or a wobbly roll. They suggest one fix a robot engineer might use, like a sensor that checks position.

Conclusion

Ask: which wheel was most accurate, and why? Real robots use wheel encoders and this exact math, then correct errors using other sensors.

Make your own lesson plan in minutes

Describe a topic and Resource Portal AI writes the objectives, materials and steps for your group.

Try Resource Portal AI